Honda Prelude Forum banner
1 - 3 of 3 Posts

·
Registered
Joined
·
61 Posts
Discussion Starter · #1 ·
Hey everyone,
I started my car yesterday after taking apart and putting back together the plenum, the throttle body and all the coolant lines. I can see the rubber hose where the coolant is leaking from, but my concern is wether or not I connected it back in the right location. There are two rubber hoses behind the MAP sensor near the throttle body that are somewhat L-shaped. They both lead to the FIV if I'm not mistaken? I'm looking for some help or visual aids if any of you have this in pic format so I can compare my setup to yours. Any help would be greatly appreciated!

Regards,
Shainin.
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top