Honda Prelude Forum banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-11 of 12 Results
  1. 5th Gen
    Hello. I have a problem with my base model 2000 lude. I finished my rebuild of the engine only a couple days ago. So far, things aren't going too bad. The car starts, it drives, but the only problem is that it has a P0335 (Crank sensor no signal) code - meaning I can't go above 3k rpms, along...
  2. 5th Gen
    Hello. I'm almost finished with my engine rebuild. Unfortunately, the coolant lines connecting the main coolant passage to the oil cooler were a pain in the ass to get on. I managed to barely get a hose clamp onto one of them, but I couldn't get the clamp onto the other one. I'm not worried too...
  3. 3rd Gen
    Alright, so the other day, while driving, my car started running really poorly, so I pulled over to find oil all over the passenger side of my engine bay. It came from the cylinder position sensor, which is connected to the exhaust cam. It seems like oil leaked into the sensor, causing it to...
  4. 5th Gen
    Let me start this off with THE MOTOR SOUNDS FINE I’m hitting VTEC all 9 yards my tachometer needle is just all over the damn place while driving I can’t post a video here otherwise I would. But it’ll go up normally bounce up from 3000 to 4000 then shoot back to 3500 then bounce up to 4500 No CEL...
  5. 4th Gen
    My H22A has the sensor on the front water neck. I have noticed that the 5th gens don't have this sensor. I do not want this sensor like the 5th gens, so what exactly is different? Is that sensor located somewhere else on the 5th gens? What will I have to do exactly to get it to work? The motor...
  6. Wanted
    I need the two sensors at the bottom of the timing belt. Mine were crushed when my timing belt went. PM me on here or email me at [email protected]
  7. 3rd Gen
    Let me first say i have done countless research. hit every forum...scimmed my manual, examined all other Hondas at junkyards. No luck. this issue is HUGE to me. please consider advise! A little over a year ago i put a new engine in my 1990 si b20a5. i was young and wreckful, and pulled on my...
  8. 3rd Gen
    Hello, thank you for checking out my thread. I accidentally pulled on my o2 sensor when pulling the engine, and my 4 prongs came out of the plug. I need to figure out, now, what 4 wires go from the harness to the 4 wire o2 sensor. I am getting bad gas mileage, and it cuts out at low rpm... (...
  9. 5th Gen
    sorry for shit quality pic - but i need to know this sensor before i stick the motor back in - this is on my h22a4 - the one on the h22a was broken (courtesy of tigerjapanese and or yellow shipping) so all i need to do is swap them... i hope but its on the back center of the block just above...
  10. 5th Gen
    Hey Im thinking about running some seafoam through a 2000 honda prelude, just because I think it would be good for the engine. And Ive heard that it can screw up you o2 sensors because of all the carbon it blows out of the exhaust. Is this true? And is there anyway I could avoid it. Could I...
  11. 4th Gen
    hey guys my father and i are currently building a custom open wheeler race car kind of like a lotus seven its going to have a h22a vtec mid mounted i have already bought a good low milage engine and maual gearbox for $300 my question is at the local pick a part (u pull it) the is currently an...
1-11 of 12 Results
Top