Parting out a whole 98 Black SH.
Located in NYC. Local pickup preferred. Will ship at buyers expense. 3.5% will be added to cost for paypal fees.
Things sold so far:
Driver side exterior door handle
Both interior door handles
Front bumper cover
Hood
Rear speakers
Passenger side window regulator/motor
Front Lower control arms
Driver side seatbelt
Motor and Transmission
AC compressor
OEM taillights
Trunk Lid
Rear bumper
Carpet
Front Subframe
Rear deck lid
Things pending:
Rear seats
E-brake lines
Center cross member beam
Front seats
Trunk mat
Things too damaged or not for sale:
Both Fenders
Driver side headlight
Rear quarter panels
OEM Cat
OEM exhaust
Headliner
Sun visors
It runs. 175k. I'll record a video tomorrow of me starting it. Probably needs a new rear main seal and or dizzy O ring. No leaking heavily, just noticed some grease underneath. It has two CEL's cause the previous owner welded a straight pipe to replace the cat. LOL
Most people are looking to swap out to the base 5 speed swap. If they want the atts (I don't think it'll bolt up to a base block) I'll include the tranny, axles, and intermediate shaft for an extra $50.
$275 picked up. I'd drive maybe 75-100 miles max to meet someone.
Hard line with reservoir
Master and slave cyl (although I'd recommend replacing them anyway due to age and miles) Pedals
Shift linkage
Shift plate
Boot with bracket
Worn shift knob
Transmission mount (assuming the SH is the same as the base)
VSS (I believe it's different from the auto)
Starter
The ECU I'm selling separately because you can easily convert the auto ECU to manual.
Hello there, I'm looking for the High Pressure Power Steering Line (hopefully not leaking ), Do you have this and are willing to sell? If so, PayPal price shipped to 85641?
I'll have to double check and make sure it wasn't damaged when we pulled the motor. It wasn't leaking, but if it does, I'm pretty sure there's a rubber gasket (part #22) that can be replaced.
Mileage on chassis? Do you have the stock suspension? I need struts, springs, top hats... FF Type II on my car are incredible pieces of shit and I can't wait to go back to stock.
Hi, was wondering if you still had the Oil pressure sensor with the black connector that sits on top of the ATTS unit.
Thanks,
Brody Warren
Status
Not open for further replies.
You have insufficient privileges to reply here.
Related Threads
?
?
?
?
?
Honda Prelude Forum
2.9M posts
61.1K members
Since 2002
A forum community dedicated to Honda Prelude owners and enthusiasts. Come join the discussion about performance, modifications, engine builds, troubleshooting, maintenance, VTEC, and more!